Striker 56 Outdoor Fan Blades: How to Replace All 5 Pieces
By CARRO Smart Ceiling Fan and lighting Outlet-Smafan | Published: 2026-11-03
Category: ハウツーガイド
Replace all five blades on your Striker 56 outdoor fan with the correct set. Follow these steps, avoid common mistakes, and confirm compatibility before you start.
Quick answer
To replace all five blades on a Striker 56 outdoor fan, first confirm you have the genuine Smafan replacement set (product 2553899), then work methodically: power off, remove the old blades, inspect the motor hub, install the new blades, and test the fan. Always replace the full set rather than mixing old and new blades.
Why replace all five blades at once
Replacing only the damaged blades on an outdoor fan can create an unbalanced set. Even slight differences in weight or pitch between old and new blades can cause wobble, noise, and extra wear on the motor. A complete 5-piece set keeps the fan running smoothly and looking uniform. The Striker 56 replacement set is sold as a full set of five, so you get consistent blades across the entire fan.
Compatibility check: not all Striker 56 fans are the same
The Striker 56 replacement blades are designed specifically for the Smafan Carro 56-inch Striker model purchased from Smafan.com. Fans sold under the same model name on other platforms may have different mounting holes or blade dimensions, so the replacement set may not fit. If you are unsure which fan you own, contact Smafan support with your order details before ordering.
Step-by-step: replacing all 5 Striker 56 blades
- Turn off power at the breaker: Switch off the circuit breaker that controls the fan, not just the wall switch. Use a voltage tester to confirm the power is off at the fan before touching any blades. Never rely on a remote or wall switch alone; the breaker is the only safe disconnect.
- Remove the old blades: While supporting the fan blade with one hand, unscrew the blade mounting screws with a screwdriver. Keep the screws in a cup or bag so they don't get lost. Repeat for all five blades. Label or bag each blade's screws separately if they are different lengths; mixing them can strip the motor hub.
- Inspect the motor hub and blade arms: Check the blade arms and motor hub for cracks, bends, or stripped screw holes. Clean any dirt or debris from the mounting surfaces. If any blade arm is damaged, replace it before installing new blades. A damaged arm will transfer stress to the new blades and cause wobble even with a perfect set.
- Install the new blades: Position each new blade on its arm and hand-tighten the screws first. Once all five blades are in place, tighten them in a crisscross pattern (like tightening lug nuts) to seat the blades evenly. Snug is enough; over-tightening can crack the blade material or strip the screw holes.
- Check balance and spacing: Before restoring power, stand back and check that all blades are at the same height and have equal gaps between them. Gently rotate the fan by hand to feel for any binding or uneven resistance. If one blade sits lower, loosen its screws and reseat it; do not bend the blade arm.
- Restore power and test: Turn the breaker back on and run the fan at low speed first. Listen for unusual noise and watch for wobble. If wobble persists, recheck screw tightness and blade alignment before trying a balance kit. A slight wobble that continues after rechecking may mean a blade is defective; contact support before using the fan regularly.
Product facts
- Striker 56" Outdoor Fan Replacement Blades only - 5 Pieces: This 5-piece replacement blade set is made for the Smafan Carro 56-inch Striker model purchased from Smafan.com only. Buying the correct set ensures the blades mount properly and maintain the fan's balance and performance.
Striker 56" Outdoor Fan Replacement Blades only - 5 Pieces
